CR TR6 and 2.5PI Mk2 Saloons and Estates

TR6 CR and 2.5PI mk 2 Throttle linkage schematic
TR6 CR and 2.5PI mk 2 Throttle linkage schematic
TR6 CR and 2.5PI Mk2 throttle linkage
Longer throttle linkage rod rod fitted to late TR6 CR and 2.5PI Mk2 cars

At Fred Millturn parts we can provide these replacement linkage rods – complete the order form here.

Please note however, there are two types that use the single linkage rod and the length of the rod is different on each type.

Early CR TR Cars (up to CR5000)

There is a single throttle linkage rod which is 13cm long. The bottom of the rod has a right-hand thread, the top has a brazed flange.

The top swivel post has no internal thread and is held in place by a star lock washer. The bottom swivel post has an internal right-hand thread.

Later CR TR’s and MK2 PI cars

There is a single throttle linkage rod which is 19-20cm long. The bottom of the rod has a right-hand thread, the top has a brazed flange.

The top swivel post has no internal thread and is held in place by a star lock washer. The bottom swivel post has an internal right-hand thread.

If you need replacement parts, you can order them using the form here.

BACK